Model |
Type |
Description |
DCS-100E |
Stand Alone Single Output Controller |
- Ethernet configuration options
- Three independently controlled channels available
- GUI, WebServer & Command Line Tools
- Software SDKs including: LabView, C++, C# and more
- For pulse widths greater than 100 µsec (10 µsec resolution)
- Overdrive currents in strobe mode limited to 5-10x
|
DCS-103E |
Stand Alone Triple Output Controller |
- High power in a compact package; a slim design at 115 x 121mm and only 45mm wide
- Three Independent Outputs
- 1-Independent Channel within each output
- Up to 90W output power, 30W per output
- GUI, WebServer & Command Line Tools
- Software SDKs including: LabView, C++, C# and more
- For pulse widths greater than 100 µsec (10 µsec resolution)
- Overdrive currents in strobe mode limited to 5-10x
|
ICS 2 |
Inline Continuous ONLY Controller |
- Fast response time – 30µS gating time
- Wash down version available
- 0 – 100%Intensity Control with optional MP-iCS
- ICS provides optimum current drive to a light head assembly, replacing external current driver units
- Intensity control is accessible via a wire which accepts a 0-10VDC voltage. This adjusts the controller between 0%-100%
- An optional accessory (MP-ICS) can be purchased to provide manual intensity control via an external potentiometer
- DC gate control input is available to enable/disable the ICS output, thereby turning the light on and off
- The ICS unit employs reverse input polarity protection.
|
ICS 3 & 3S |
Inline Control System; Combined Strobe / Continuous Operation |
- Continuous and strobe operation in one package and built into the power cable
- Active Overdrive Technology™ ensures maximum pulsed power regardless of pulse width
- Optional M12 Connector allows plug and play operation – no adapters required
- Seamless switching between strobe and continuous modes with no adapters or changes in wiring required
- ICS 3S version is identical, but with the default being off
|
Pulsar 320 |
Stand Alone Dual Output Controller |
- Compact, high power pulse (strobe only) current source
- Controlled locally w/PC and USB2, or remotely with built-in Ethernet interface
- 50A per output; 100A total output
- For pulse widths down to 1 µsec (1µsec resolution)
- Capable of overdriving currents 10-30x in strobe mode
|